Abstract
In this paper, Component Mode Synthesis (CMS) is used as a basis for predicting power flow in complex structures. Each component structure may be represented by a separate finite element model. The Craig-Bampton method of CMS is used to formulate a reduced order model of the entire structure. The CMS matrices are further reduced by finding 'characteristic constraint (CC) modes'. These modes are computed by performing an eigenanalysis of the partitions of the CMS mass and stiffness matrices that correspond to the degrees of freedom (DOF) of the constraint modes. A relatively small number of CC modes that capture the primary interface motion are selected to yield a highly reduced order CMS model. The power flow is then calculated by solving the CC mode DOF and corresponding coupling forces. This formulation renders efficient and accurate prediction of vibration transmission in the low- to mid-frequency range. It is shown that the total power flow between component structures is well approximated by considering only the power flow through the selected CC modes. The performance and accuracy of the method are illustrated by examples of two coupled beams, a cantilever plate, and a composite armor vehicle.
Original language | English |
---|---|
Pages (from-to) | 908-917 |
Number of pages | 10 |
Journal | Collection of Technical Papers - AIAA/ASME/ASCE/AHS/ASC Structures, Structural Dynamics and Materials Conference |
Volume | 1 |
Issue number | II |
State | Published - 2000 |
Event | 41st AIAA/ASME/ASCE/AHS/ASC Structrures, Structural Dynamics, and Materials Conference and Exhibit AIAA/ASME/AHS Adaptive Structures Forum AIAA Non-Deterministic Approaches Forum AIAA Space Inflatables Forum - Atlanta, GA, USA Duration: 3 Apr 2000 → 6 Apr 2000 |